No$gba v2.8 Changelog: - help: updated gbatek standalone version 2.8 (with fairly complete dsi specs) - dsi: no$gba is now having (more or less) working non-experimental DSi support - dsi/cartloader: auto-encrypts modcrypt area if needed (requires good sha1hmac) - gba/snap: fixed skipping empty-nds-chunks in gba-snapshots (thanks shiny.exe) - newmem: avoids borland tasm32/tlink32 linker-error on "arm_memxlat_non_tcm" - dsi/help: added list of known regions/countries (only europe is known yet) - dsi/help: better ndma description (logical/physical blocks, and repeat modes) - wifi/help: added new DSi access points specs (wpa/wpa2, and proxy settings) - wifi/help: added formerly unknown NDS access points specs (mtu, ssid length) - dsi/help: added average microphone specs for ARM7 side (A/D side is unknown) - dsi/emu: supports fake camera access (outputting some dummy snow picture) - dma: added warning on unsupported dma/ndma types (wifi,sd/mmc,aes,mic,mainmem) - debug: fixed $profiler_id indices for dma-channel/mode names - dsi/emu: supports basic aes and sd/mmc init (32bit 44xxh, 16bit 48xxh/49xxh) - dsi/emu: supports i2c access (8bit 450xh) and gpio access (16bit 4C0xh) - dsi/emu: supports new touchscreen controller (different SPI protocol as NDS) - dsi/help: added description for new touchscreen controller (position/status) - dsi/help: added notes on touchscreen in nds mode (no pressure & temperature) - dsi/help: identified the dsi cameras as Aptina MT9V113 image sensors - dsi/help: added initialization/transfer flowcharts for cameras on ARM9 side - dsi/help: added initialization flowchart for Aptina cameras on ARM7 side - dsi/help: added initialization flowchart for Unknown cameras on ARM7 side - dsi/help: added undocumented aptina regs, and aptina REV3 additions - dsi/help: added general dsi notes (eg. dsi detection) and info on exploits - dsi/help: added notes on basic differences to NDS mode (changed details) - dsi/help: added info about (mostly unknown) eMMC encryption (via CID register) - dsi/help: added behaviour of SPI powerman (with differences in DSi/NDS modes) - gba/nds/dsi/help: added BIOS RAM info (initial RAM content and IRQ/SWI usage) - nds/help: cart header[06Eh] Secure Area Delay, and ROMCTRL.Bit28 gap CLKs - nds/help: info on rom chip id bit31 cart protocol variant (gap/repeat/delay) - xboo: supports dumping carts with rom chip id bit31=1 (protocol differences) - dsi/debug: added tty.log options for I2C commands and NDS cartridge commands - dsi/debug: prevents warnings on bigger New WRAM areas (unlike 32K for NDS) - dsi/debug/emu: allows bigger DSi7/DSi9 bios regions (bigger than NDS7/NDS9) - dsi/emu: allows reading/writing more scfg registers (as far as used by games) - dsi/emu: initializes more scfg regs on reset (with suspected/guessed values) - dsi/i2c/help: added Aptina MT9V113 camera specs (i2c registers and variables) - dsi/i2c/help: added many details on bptwl chip (led/volume/misc controller) - dsi/help: described power-button modes (auto-reset, irq, forced-power-off) - dsi/help: major corrections to I2C control reg, added I2C signals chapter - dsi/help: added details like headphone-connect bit, game-cart-insert-bit - dsi/cartloader: bugfixed cartloader odd modcrypt lengths (eg. cooking coach) - dsi/help: added GPIO specs (data in/out/direction, irq edge/enable) - dsi/help: removed dsi cart protocol, instead added cmd_3Dh notes in ds chapter - dsi/help: hardware/software info on wiring the eMMC chip to PC card readers - dsi/help: info on sd/mmc I/O (from TC6387XB datasheet, tmio_mmc, dsi dumps) - dsi/help: added specs for sd/mmc protocols (commands, repsonses, registers)